Resetting your SMART+ Motion and Temperature Sensor

How to Reset your SMART+ Contact and Temperature Sensor

If you are having trouble pairing your Motion and Temperature Sensor, or it fails to respond to commands, you may need to reset the sensor and re-pair it to your system. To do this, watch the video or follow the instructions below.

  1. Remove the device from your smart home set up.
  2. Remove the battery from your motion sensor, and leave it out for at least 6 seconds.
  3. Locate the gray button on the left hand side of the sensor. Hold down this button while simultaneously re-inserting the battery.
  4. Continue holding down the button for an additional 3 seconds until the light starts flashing blue, indicating that it has been reset and is in pairing mode.

These directions are incorrect for model 72923.

  1. Remove battery for 6+ seconds.
  2. Hold switch and insert battery.
  3. While red light is on quickly release button and press & release again
  4. Light should change to blue/green

©2017 LEDVANCE, LLC. All Rights Reserved. View our Privacy Policy.